NEC MULTEOS M40 - Manual (Page 36)

English-32
OSD Controls
- continued
RED DELAY
GREEN DELAY
BLUE DELAY
RED SHARPNESS
GREEN SHARPNESS
BLUE SHARPNESS
SOG PEAK.
VIDEO EQ.
RGB/HV input only
SYNC TERMINATE
RGB/HV input only
Adjusts the phase of the red signal.
Adjusts the phase of the green signal.
Adjusts the phase of the blue signal.
Adjusts the performance degradation of the RED signal.
Adjusts the performance degradation of the GREEN signal.
Adjusts the performance degradation of the BLUE signal.
Adjusts the shape of Sync on Green signal.
Optimize the shape (Tailing) of RED, GREEN and BLUE signals.
Selects the terminate resistance for matching the cable impedance.
DVI MODE Choose the DVI mode based on the input device connected via DVI connector.
DVI-PC
DVI-HD
When a PC or similar equipment is connected.
When a DVD player is connected.
SCAN CONVERSION
All inputs except for VGA,
RGB/ HV
Selects the IP (Interlace to Progressive) conversion function.
Note: For DVI input "DVI-HD" needs to be enabled in the DVI mode.
PROGRESSIVE
INTERLACE
Converts interlaced signals to progressive.
This is the default setting.
Disables IP conversion. This setting is best suited for motion pictures, but increases the
risk of image retention.
SCART MODE
Input mode for devices using SCART connectors.
S-VIDEO MODE
Selects the S-Video input port function.
PRIORITY
SEPARATE
When an S-Video cable is connected to the S-Video input, it will have priority over
the composite input port.
The S-Video port and Composite port can be selected as independent input ports.
COLOR SYSTEM
VIDEO input only
The selected Color System depends on the video format of the input signal.
AUTO
NTSC
PAL
SECAM
4.43NTSC
PAL-60
Automatically chooses Color System setting based on input signal.
SCAN MODE
HDMI, DVD/HD, VIDEO, TV
input only
Some video formats may require different scanning modes in order to best display the im-
age.
OVER SCAN
UNDER SCAN
Image size is larger than what can be displayed. The image edge will appear cropped.
Approximately 95% of the image will be shown on the screen
Image size stays within the display area. The whole image is displayed on the screen.
ADVANCED OPTION
RESET Resets the following settings within the ADVANCED OPTION menu back to factory set-
ting: INPUT DETECT, LONG CABLE ON/OFF, LONG CABLE MANUAL, DVI MODE, SCAN CONVER-
SION, S-VIDEO MODE, SCAN MODE.
FACTORY RESET Resets OSD options back to factory settings EXCEPT FOR: CHANGE SECURITY PASS-
WORD and SECURITY PASSWORD.