National Instruments CFP-CB-3 - Manual (Page 11)

© National Instruments Corp. 11 cFP-CB-1/2/3/4
Installing the cFP-CB-x
To install the cFP-CB-x, refer to Figure 14 and complete the
following steps:
1. Align the captive screws on the cFP-CB-x with the holes on the
backplane. The shape of the I/O connector on the cFP-CB-x
prevents backward insertion.
2. Press firmly to seat the cFP-CB-x on the backplane.
3. Using a number 2 Phillips screwdriver with a shank of at least
64 mm (2.5 in.) length, tighten the captive screws to 1.1 N
⋅ m
(10 lb
⋅ in.) of torque. The nylon coating on the screws prevents
them from loosening.
Figure 14. Installing the cFP-CB-x
1 Connector Block Captive Screws
2 I/O Module 3 Screw Holes for Connector Block
4 Socket for Connector Block
3
4
3
2
1
1