National Instruments CFP-CB-3 - Manual (Page 9)

© National Instruments Corp. 9 cFP-CB-1/2/3/4
Installing the Strain-Relief Bar
(cFP-CB-1 and cFP-CB-3 Only)
The cFP-CB-1 is shipped with two strain-relief bars, one with a
foam cushion for wires and one with grooves for jacketed cables.
The cFP-CB-3 has one foam-cushion strain relief bar. The tie-wrap
anchors on the connector block provide additional strain relief.
Figure 11 shows the two strain-relief bars.
Figure 11. cFP-CB-1 and cFP-CB-3 Strain-Relief Bars
Choose the strain-relief bar that suits your application and
complete the following steps:
1. Using a number 2 Phillips screwdriver, install the strain-relief
bar on the connector block as shown in Figure 12.
Figure 12. Installing the Strain-Relief Bar