National Instruments CFP-CB-3 - Manual (Page 4)

cFP-CB-1/2/3/4 4 ni.com
Wiring to the Connector Block
Refer to the I/O module operating instructions for information
about wiring configurations, including detailed wiring diagrams
and fuse recommendations.
Note To protect the FieldPoint system and connected
devices, install appropriate external fuses on all
terminals. Refer to the
Specifications section for the
current limits of the cFP-CB-x terminals.
Note The V terminals are internally connected to each
other and the C terminals are internally connected to each
other.
Caution Ensure that hazardous voltage wiring is
performed only by qualified personnel adhering to local
electrical standards.
Wirng to the cFP-CB-1 and cFP-CB-3
1. Loosen the top cover screws and remove the cover. Refer to
Figure 5.
Figure 5. Removing the Top Cover from the cFP-CB-x