Nikon ProStaff Team Realtree 3-9x40 - Manual (Page 4)

• The riflescope 3-9x40, 3-9x50 has a variable magnification from 3 to 9X,
2-7x32 from 2 to 7X.
To change powers, just rotate the power selector ring until the desired
magnification appears adjacent to the power index dot.
(3) Adjustment of the riflescope
Sighting through the riflescope, align the rifle with your aiming point on the
target and shoot a trial round. If the bullet does not hit the aiming point, adjust
the elevation and windage, as follows:
• If the bullet hits under the aiming point, turn the elevation adjustment
(counter-clockwise) in the direction of the arrow marked “U” for up as in
Fig. 3-5. If the bullet hits high, turn adjustment (clockwise) in the direction
of the arrow marked “D” for down.
• If the bullet hits to the right of the aiming point, turn the windage
adjustment (clockwise) in the direction of the arrow marked “L” for left as
in Fig. 3-6. If the bullet hits to the left of the aiming point, turn adjustment
(counter-clockwise) in the direction of the arrow marked “R” for right.
• After the reticle has been adjusted to the point of impact, insert the tip of
a screwdriver into the slot of the scale ring and rotate the scale ring so
that the “ ” is lined up with the index dot. (Fig. 3-7, Fig. 3-8)
1) Lock Ring
2) Eyepiece Adjustment
3) Eye Relief
Note:
• The windage and elevation scales of the riflescope 3-9x40, 3-9x50, 2-
7x32, and 4x32 are calibrated in division of
minute of angle with a click
at intervals of
minute if angle (one division).