Napco Security Technologies GEM-RP3DGTL - Manual (Page 10)

10
T U R N I N G O F F T H E A L A R M ( D I S A R M I N G ) W H E N R E T U R N I N G
1. Upon entry, the red ARMED light will be on and the keypad sounder will come on as a reminder to disarm the panel.
During the final 10 seconds, the sounder will pulse a warning signal.
2. Immediately enter your code, then press the
J
button. The sounder will silence and the red ARMED light will go out.
Note: If you enter an invalid code, the keypad will beep 4 times, signifying an error. Re-enter your code immediately.
Alarm Indication
If the red ARMED light is flashing upon entry, an alarm occurred while you were out. (The display will scroll the
number(s) of the violated zone(s).) Proceed with caution! If you suspect that an intruder may still be on the premises, leave
immediately and call authorities from a neighbor's phone.
To silence an audible alarm,
1. Enter your code and press the
J
button. After the system is disarmed, the window will continue to display the
number(s) of the zone(s) violated.
2. To reset the display, note the zones violated, then press the C button.
GEM-RP3DGTL.pub
page 10 Wednesday, August 18, 1999 14:03