Napco Security Technologies GEM-RP3DGTL - Manual (Page 29)

29
S Y S T E M T R O U B L E E R R O R C O D E S
E01-00 AC power failure.
E02-00 System low battery.
E03-00 Communication failure.
E04-NN RF transmitter supervisory
Failure; NN = transmitter
number.
E05-NN RF transmitter low battery
condition; NN = transmitter
number.
E06-NN Receiver response failure;
NN = receiver number.
E07-00 Download failure.
E08-00 Telephone line failure
E09-00 System cold start.
E10-NN Keypad response failure;
NN = keypad number.
E11-NN Keypad tamper condition;
NN = keypad number.
E12-NN Expansion zone module
response failure;
NN = module number.
E13-NN Expansion zone module
tamper condition;
NN = module number.
E14-NN Relay board response
failure; NN = relay board
number.
E15-NN Rf transmitter tamper
condition; NN = transmitter
number.
E16-NN Receiver jammed;
NN = receiver number.
E17-NN Receiver tamper condition;
NN = receiver number.
E18-NN Key fob transmitter low battery;
NN = key fob transmitter
number.
E19-00 User Program memory error.
E20-00 Dealer Program memory error.
E21-00 System shutdown.
E22-NN Sensor activity failure;
NN = zone number.
E23-00 Burglary bus failure.
E24-00 Service message.
E39-00 Receiver capacity error.
E40-00 RF Self Test Fail
E50-00 Alarm Output Supervisory
E51-00 Bell Supervisor y
Your control panel is capable of detecting a variety of troubles that may affect system performance. In the unlikely event
that a problem should occur, the SYS TBL (system trouble) light will display in the window along with one or more of the
following error codes. Several of these messages are intended for use by your installer or servicer. If any message
appears that is unfamiliar to you, call your security professional for service.
GEM-RP3DGTL.pub
page 29 Wednesday, August 18, 1999 14:03