Napco Security Technologies GEM-RP3DGTL - Manual (Page 7)

7
S E T T I N G T H E A L A R M ( A R M I N G ) W H E N L E A V I N G
If you attempt to arm with a system trouble, a 3-second tone will sound at the keypad.
(See SYSTEM TROUBLE ERROR CODES for descriptions of codes.) The window will
display “P”. If you cannot correct the problem immediately, pressing the
C button will
enable you to arm in this condition. Be sure to call for service as soon as possible.
Area Arming (Optional)
In a system that has been partitioned into multiple areas, one or more areas may be
armed while others remain disarmed.
Manager's Mode. The Manager's Mode, if enabled, provides quick access to other
areas without the system status display. (This is not a high-security feature.)
To arm any area,
1. Press the numerical key representing the area number.
2. Press the G button then the
J
button. In effect, you will now be in that area.
3. Enter your code, then press the
J
button to arm. Note: Your code must be valid in
that area.
To arm all areas simultaneously (including the area you are in), press 9 , G , enter
your code and press the
J
button.
If any zone is not secured, the keypad will display “P”. All problem zones in the
respective area(s) must be secured or bypassed before the area can be armed. Note: If a
system trouble is indicated, the system cannot be armed using this method.
To disarm all areas, press 0 , G , enter your code and press the
J
button.
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
P
GEM-RP3DGTL.pub
page 7 Wednesday, August 18, 1999 14:03