Net Optics Director - Manual (Page 21)

Director
17
Configure Director using the CLI
You should be logged into the Director CLI. The factory-set default values for Director are:
Username: • admin
Password: • netoptics
IP Address: • 10.60.4.180 (address for remote CLI, and for Indigo manager software, when available)
Netmask: • 255.0.0.0 (associated with IP Address)
Manager IP Address: • 192.168.1.2 (address for SNMP traps)
Gateway IP Address: • 10.0.0.1 (associated with Manager IP Address)
All ports enablesd •
A complete list of CLI commands can be viewed by typing Help at the CLI prompt. It is also provided in Appendix B.
You will now use the CLI to:
Change the login password •
Assign a new IP Address, Netmask, and Gateway IP Addresses •
Assign new remote manager IP Address •
Change port modes •
Set the date and time •
Save and load Director configurations •
Try out the CLI Help command •
Your CLI screen should be displaying the "Net Optics:" prompt as shown here:
Net Optics>
If you do not see the "Net Optics>" prompt, try typing Help followed by the Enter key. If the prompt is still not dis-
played, repeat the instructions in the preceding section
Connect the local CLI Interface
or
Connect the remote
CLI Interface
and log in again.
Change Director Password
It is strongly recommended that you change the login password from the default to provide security against
unauthorized access.
To change the login password:
Enter 1. user mod name=admin pw=<new password> priv=1. The password is changed.
Record the new password in a secure location. 2.
If you wish to change the user name, use the user add command to create a new user account under that name. You can
use the user del command to delete the admin account if you wish.