Net Optics Director - Manual (Page 42)

Director
38
Enter 4. filter list to view the pending filter list.
Net Optics> filter list
Filter #1
src_mac=00:00:00:00:00:00 dst_mac=00:00:00:00:00:00
src_ip=0.0.0.0/255.255.255.255,dst_ip=0.0.0.0/255.255.255.255,ip_proto=0006
l4_src_port=0000,l4_dst_port=0000,vlan=0000,action=drop
in_ports=
Filter #2
src_mac=00:00:00:00:00:00 dst_mac=00:00:00:00:00:00
src_ip=0.0.0.0/255.255.255.255,dst_ip=0.0.0.0/255.255.255.255,ip_proto=0000
l4_src_port=0000,l4_dst_port=0000,vlan=0000,action=redir
in_ports=n1.1
redir_ports=m.1
Filter #3
src_mac=00:00:00:00:00:00 dst_mac=00:00:00:00:00:00
src_ip=0.0.0.0/255.255.255.255,dst_ip=0.0.0.0/255.255.255.255,ip_proto=0000
l4_src_port=0000,l4_dst_port=0000,vlan=0000,action=redir
in_ports=n1.2
redir_ports=m.2
IPv4 filter resource utilization: 2%
Net Optics>
Filter list command Figure 43:
Repeat steps 3 and 4 until the pending filter list is consistent with the desired filter configuration. 6.
Enter 7. filter commit. The contents of the pending filter list are copied to the CAM, activating the new filter
configuration.
Pending filter list
Address Filter
1 n1.1 ip_proto=TCP action=drop
2 n1.1 m.1
3 n1.2 m.2
CAM
Address Filter
1 n1.1 ip_proto=TCP action=drop
2 n1.1 m.1
3 n1.2 m.2
After filter commit Figure 44: