Nx Networks 3000 - Manual (Page 5)

3000 Series User Guide v
Safety Information
Caution
For your personal safety, follow these guidelines
before installing the 3000 Series router.
• Use only indoors. The unit is not intended for any other use.
• Disconnect power supply cord in case of emergency.
• Plug the unit directly into a grounded outlet.
• Disconnect power supply cord and all other attached cables prior to
removing the top cover to install, remove, or reconfigure the customer
accessible modules defined in this manual.
WARNING
Removal of the internal safety cover,
identified by this warning label, will
expose a hazardous voltage. Only trained,
authorized personnel may access this area
after removal of the power cord.
• Be sure you have the required power for the unit. The unit requires 100-
240 VAC, 50-60 Hz power.
•
For 110 Volt Operation: Use UL Listed/CSA labeled cord set
consisting of a minimum 18 AWG, Type SVT or SJT three-conductor
cord terminating in a molded connector body that has an IEC CEE-22
female configuration on one end and a molded-on parallel blade
grounding type attachment plug rated 15A, 125V configuration (5-
15P) at the other end.
• For 230 Volt Operation ( North America ): Use a UL Listed/CSA
labeled cord set consisting of a minimum 18 AWG, Type SVT or SJT