National Instruments NI sbRIO-960x - Manual (Page 18)

NI sbRIO-960x 18 ni.com
Resetting the Network Configuration
of the sbRIO Device
If the sbRIO device is not able to communicate with the network, you can
use the IP RESET switch to manually restore the device to the factory
network settings. When you restore the device to the factory network
settings, the IP address, subnet mask, DNS address, gateway, and Time
Server IP are set to
0.0.0.0 . Power-on defaults, watchdog settings, and
VIs are unaffected.
Complete the following steps to restore the device to the factory network
settings.
1. Move the IP RESET DIP switch to the ON position.
2. Press the Reset button.
3. Move the IP RESET switch to the OFF position.
Table 4. Status LED Indications
Number of Flashes Indication
1 The device is unconfigured. Use MAX to configure the device. Refer to
the Measurement & Automation Explorer Help for information about
configuring the device.
2 The device has detected an error in its software. This usually occurs
when an attempt to upgrade the software is interrupted. Reinstall
software on the device. Refer to the Measurement & Automation
Explorer Help for information about installing software on the device.
3 The device is in safe mode because the Safe Mode DIP switch is in
the ON position. Refer to the
Configuring DIP Switches section for
information about the Safe Mode DIP switch.
4 The software has crashed twice without rebooting or cycling power
between crashes. This usually occurs when the device runs out of
memory. Review your RT VI and check the memory usage. Modify
the VI as necessary to solve the memory usage issue.
Continuous flashing
or solid
The device may be configured for DHCP but unable to get an IP address
because of a problem with the DHCP server. Check the network
connection and try again. If the problem persists, contact National
Instruments.