Nokia 6800 Series - Manual (Page 66)

6800/7000 Series - Distribution and Routing Products Installation and Operation Manual 39
User Interface Chapter 4: USM-6800 PAL/NTSC Monitoring Encoder Module
User Interface
The following chart describes the Mode Select switch and Toggle switch
functions:
Mode Select Switch Toggle Switch
Position Function Down Up
0 Operate • Normal operation; Toggle switch disabled.
• Store any changed settings to *EEPROM.
1 Standard Force : Forces the
configuration of the
board into 525 or 625
line standard
depending on position
2
of Mode Select switch
configuration.
Auto : The
configuration of the
board 525 or 625 line
standard depends on
the detected standard.
2 Force
Standard 625 : Forces the board
configuration into the
625 line standard.
Position 1 of the Mode
Select
switch should be
configured for the
Force
mode.
525 : Forces the board
configuration into the
525 line standard.
Position 1 of the Mode
Select
switch should be
configured for the
Force
mode.
3 RESERVED
4 Output Component : Generates
RGB or YUV analog
outputs depending on
position 6 of the Mode
Select
switch
configuration.**
Composite : Generates
the YC=2 composite or
Y composite analog
outputs depending on
position 5 of the Mode
Select
switch
configuration.
Data is stored to the
*EEPROM under the
following conditions:
-
Any change in the Mode
Select switch position, only if
data has changed.
-After 30 seconds of
inactivity, only if data has
changed.
There are discrete sets of data
for 525 and 625; only the data
for the standard in use is
stored.
**In the Component
configuration, one composite
output is generated as well as
the RGB or YUV analog
outputs.