Clock set/adjustment, Trip computer (if so equipped), Instrument brightness control/trip change button – NISSAN 2010 Frontier User Manual

Page 10

Advertising
background image

8

CLOCK SET/ADJUSTMENT

Press and hold the DISP CLOCK button until it beeps. The hours will start flashing.

Press the CAT/FOLDER or SEEK/TRACK buttons to adjust the hours.

Press the DISP CLOCK button to switch to the minute adjustment.

Press the CAT/FOLDER or SEEK/TRACK buttons to adjust the minutes.

Press the DISP CLOCK button to store the time and exit clock set mode.

TRIP COMPUTER (if so equipped)

The trip computer readout is in the speedometer display. With
the ignition key in the On position or the vehicle running, you
can select an item by pressing the TRIP CHANGE button on the
instrument panel. it can show the following items:

TRiP “A” – Measures the distance of one specific trip.

TRiP “B” – Measures the distance of a second specific trip.

diSTAnce TO eMPTY (dte) – estimates the distance that can be driven before refueling.

AVeRAGe SPeed (MPH or km/h) – Shows the average speed since the last reset.

AVeRAGe fueL cOnSuMPTiOn (mpg or L/100km) – Shows the average fuel

consumption since the last reset.

JOuRneY TiMe – Shows the time since the last reset.

ReSeT – Press the TRIP CHANGE button on the instrument panel for more than 1 second

to reset the trip odometer to zero.

INSTRUMENT BRIGHTNESS CONTROL/TRIP CHANGE BUTTON

The instrument brightness control operates when the headlight control

switch is in the

or

position.

Turn the control to adjust the brightness of the instrument panel lights.

Press the TRIP CHANGE button to select trip computer features.

FOUR-WHEEL DRIVE (4WD) SHIFT SWITCH (if so equipped)

This system provides three positions so the driver can select

the desired drive mode according to driving conditions.

2WD – dry, paved roads.

4H – Rocky, sandy or snow-covered roads. (Before placing

4Wd shift switch in 4H position from 2Wd, ensure vehicle

speed is less than 62.5 MPH [100 km/h]).

4LO – When maximum power and traction are required

(steep grades, rocky, sandy or muddy roads).

nOTe: The vehicle must be stopped and in N (NEUTRAL) with the brake pedal depressed when
shifting into and out of 4LO.

Advertising