NISSAN 2010 Frontier - Manual (Page 5)

3
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the On position to
activate the windshield wipers.
Move the lever to the following positions to operate
the windshield wipers:
1A
intermittent (INT) – front wipers operate
intermittently and can be further adjusted by
twisting the time control ring 1B
.
02
Low Speed (LO) – continuous low-speed operation of front wipers.
03
High Speed (HI) – continuous high-speed operation of front wipers.
04
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
Pull the lever toward you to activate front washer fluid and several sweeps of the wipers.
HEADLIGHT AND TURN SIGNAL CONTROL
TO AcTiVATe THe AuTOLiGHT SYSTeM (if so equipped):
Turn the headlight control switch 01
to the AUTO position
to activate the autolight system. The autolight system can:
Turn the headlights on automatically when it is dark.
Turn the headlights off automatically when it is light.
keep the headlights on for 45 seconds after you turn the ignition switch to Off and all
doors are closed.
TO deAcTiVATe THe AuTOLiGHT SYSTeM:
Turn the headlight control switch 01
to the OFF,
or position.
HeAdLiGHT cOnTROL SWiTcH
Turn the headlight control switch 01
to the
position to turn on the front parking,
tail, license plate and instrument panel lights.
Turn the headlight control switch 01
to the position to turn on the headlights.
All other lights remain on.
fOG LiGHT OPeRATiOn (if so equipped)
Turn the switch (inside collar) 02
to the position to turn on the fog lights.
Turn the switch (inside collar) 02
to the OFF position to turn off the fog lights.
HiGH BeAM
Push the headlight control switch forward A
to select the
high beam function. The blue indicator light illuminates.
Pull the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
Pull and release the headlight control switch B
to
flash the headlight high beams on and off.