Folding the rear bench seat (crew cab model only), Utili-track™ channel system (if so equipped), Homelink – NISSAN 2010 Frontier User Manual
Page 15: Universal transceiver (if so equipped)
13
FOLDING THE REAR BENCH SEAT (Crew Cab Model only)
fOLdinG THe SeATBAck dOWn:
To fold the rear bench seatback down to access the
jacking tools, pull up on the straps
01
located on the
outer edge of the seatbacks and fold the seatback
forward.
fOLdinG THe SeAT BASe uP
To fold the rear bench seat base up to access the
under-seat storage bins:
Lift up on the lever
02
located on the side of the
seat, while lifting up the front of the seat cushion.
Repeat this process to raise and secure the seat
cushion on the other side of the vehicle. fold the
bottom of the seat cushion toward the back of the
vehicle until it locks into place.
Repeat this process to raise and secure the seat cushion on the other side of the vehicle.
UTILI-TRACK™ CHANNEL SYSTEM (if so equipped)
The utili-track™ channel system allows you to move
tie-down clamps in the bed to the best location to
secure a load.
The tie-down cleats must be installed so the
clamp is properly seated in the notches in the
rail. if the tie-down cleat is not seated in the
notches, it will not be flush with the rail and
cannot be properly tightened. The bolt in the
center of the cleat must be tightened hand-tight
(20 – 40 inch pounds).
check the tightness of the tie-down cleat periodically during a trip to make sure the center
bolt has not become loose.
The channel end stoppers can be used to help prevent cargo from sliding or shifting off the end
of the truck bed. They must be installed so they are properly seated in the detents in the channel.
HOMELINK
®
UNIVERSAL TRANSCEIVER (if so equipped)
SYSTeM OPeRATinG TiPS
Garage doors, electrical gates, entry doors, etc., will be activated during programming.
To avoid injury, make sure that people and objects are clear of all doors or gates during
programming. Your vehicle’s engine should be turned off while programming the
HomeLink
®
Transceiver.
To program your HomeLink
®
Transceiver to operate a garage door, gate, or entry door
opener, home or office lighting, you need to be at the same location as the device.
01
02