Nortel Networks CALLPILOT 555-7101-226 - Manual (Page 42)

Preinstallation requirements Standard 1.01
42 CallPilot
Replacing the side cover
Introduction
When you are satisfied that the server was not damaged during shipment,
reinstall the side cover.
To replace the side cover
1 Align the right edge of the server’s side cover with the inside ledge at the
front of the server.
2 Ensure that the cover lays flat along the side of the server.
3 Insert the tabs along the top and bottom edges of the server’s cover
inside the slots along the top and bottom of the server.
4 Push the cover towards the front of the server until the tabs firmly
engage in the chassis.
Note: When correctly engaged, the cover clicks into place.
5 Tighten the two thumbscrews on the back of the server.
.
CAUTION
Risk of equipment damage
Ensure that there are no tools or loose parts inside the server
chassis before replacing the side cover.