Nortel Networks CALLPILOT 555-7101-226 - Manual (Page 64)

Installing the server and connecting the peripheral devices Standard 1.01
64 CallPilot
To connect the server to power
1 Plug the server’s AC power cord into the server’s rear panel.
2 Plug the other end into a wall receptacle or power bar.
To start the server
1 Press the server’s power switch to start the server.
2 Observe the Power-On Self-Test (POST) and initialization messages on
the monitor.
3 When the following menu appears on the monitor, choose the first option
to start Windows NT:
OS Loader V4.00
Please select the operating system to start:
Windows NT Server Version 4.00
Windows NT Server Version 4.00 [VGA mode]
.
WARNING
Risk of personal injury and risk of hardware failure
You must connect the power outlets that are used by the
CallPilot server and its peripheral devices to the same
single-point ground reference as the one used by the
Meridian 1 switch or Succession 1000 system with MGate
cards connected to the CallPilot server.
If this requirement is not met, power transients can cause
personal injury, hardware failure, or both. For more
information on single-point grounding requirements, refer to
the discussion of safety guidelines in CallPilot Installation and
Configuration Part 1: Installation and Maintenance Overview
(NTP 555-7101-210).