Nortel Networks ROADSTER 56K - Manual (Page 6)

NetComm Roadster series 56K UsB modem �m�5�6� �m�5�6� 5�6�
6 www.netcomm.com.au
Hardware setup
This chapter contains detailed instructions on how to install and configure the 56Kbps USB modem, as well as how to verify if your
installation is correct. We recommend that you follow the steps accordingly to avoid future problems.
Installing the 56Kbps USB Modem
1. turn off your PC and unplug the aC power supply from the system.
. Please connect the UsB modem and PC with UsB cable.
3. Please connect the 56Kbps UsB modem to the telephone line and telephone set, as per the following steps.
a. Locate an available RJ-11 modular jack telephone outlet.
b. Insert one end of the modular cord that came with your USB 56Kbps modem into the RJ-11 modular jack marked “LINE” on the
modem. Then plug the other end into the modular jack on wall outlet. See below Figure.
c. Plug the RJ-11 jack of the telephone set into the RJ-11 jack marked “PHONE” on the modem, if required. See below figure.
USB
Telephone
(Optional)
d. If the telephone set is connected to the 56Kbps USB modem via a telephone cord, lift the telephone handset, and check for a
dial tone.