Network Technologies RACKMUX-V17-8UNV - Manual (Page 24)

NTI RACKMUX KVM Drawer with NODEMUX Switch
20
RV- read unit software version
FORMAT: RV XX,00
RV= "read software version" command followed by at least one space
AA= unit address
00= command for the address location in memory of the software version
RESPONSE:
-OR-
?<CR> (syntax or transmission error occurred)
CF - reset all connected units, regardless of address, to factory default configuration settings
WARNING: THIS COMMAND WILL RESET ALL RS232 DAISY-CHAIN-CONNECTED NODEMUX SWITCHES TO
FACTORY DEFAULT SETTINGS. IF OTHER SWITCHES ARE DAISY CHAINED VIA RS232, DISCONNECT THEM BEFORE
SENDING THIS COMMAND.
FORMAT: CF 00
RESPONSE: (After 10-20 seconds)
COMMAND OK
RESET SWITCH CONFIGURATION IS COMPLETE
PLEASE RESET SWITCH POWER
FOR CHANGES TO TAKE EFFECT