NetComm 5303 User Manual
Page 6

6
2
The short phone cord has a different connector on each
end. Connect the end with the larger connector (RJ45) to
the remaining jack (labeled with a phone jack icon )
on the 48 V DC Power Adapter. Refer to Figure 2.
3
Connect the other end of the short phone cord to the PSTN
Adapter, and then plug the PSTN Adapter into the wall jack.
4
The power cord has a different connector on each end. Con-
nect the end with the smaller connector (C7) to the 48 V DC
Power Adapter, and then plug the larger end of the power
cord into an electrical outlet. Refer to Figure 3 for the over-
view of the 5303 Conference Phone setup.
Note: As a safety precaution, place the 48 V DC Power Adapter
and all cords neatly along the wall near the electrical
outlet and wall jack.
5
Using a felt-tip marker, write the unit’s phone number on
one of the Phone Number Tags, and attach it to the phone
cord. Refer to Figure 3.
Note: If you experience difficulty setting up a three-way
conference call (or activating other service provider
features), change the hook flash time. For more
information, see the section on the ‘Installation Menu’.
Figure 2: 48 V DC Power Adapter
Caution: Mitel Networks-supplied 48 V DC Power Adapters are
the only adapters accepted by Mitel Networks Corporation for
connection to the 5303 Conference Phone.