Nikon 885 - Manual (Page 23)

45 44
4 Close the battery-chamber cover
3 Insert the battery
Step 2—Insert the Battery
Your camera is powered by a single rechargeable Nikon EN-EL1
lithium-ion battery or a non-rechargeable 2CR5 (DL245) lithium battery.
Note that either the Nikon EN-EL1 lithium-ion battery or 2CR5 (DL245)
lithium battery may be supplied with your camera, depending on the
area of purchase.
1 Turn the camera off
2 Open the battery-chamber cover
Tu
torial—First Steps
Read Battery Warnings
Read and follow all warnings and instructions supplied by the battery
manufacturer.
Charge the rechargeable Nikon EN-EL1 lithium-ion battery
We recommend that you use the battery charger to charge the EN-EL1 battery
before use since the EN-EL1 battery is not fully charged at shipment.
Instructions for charging the battery may be found in the instruction manual
supplied with the charger. Note that the 2CR5 (DL245) lithium battery is not
rechargeable.
Caution Regarding Battery Use
• In some cases the “WARNING!! BATTERY EXHAUSTED” message may not
appear in the monitor if an exhausted battery is re-inserted into the camera.
• The rechargeable Nikon EN-EL1 lithium-ion battery should be removed and
recharged as soon as the message “WARNING!! BATTERY EXHAUSTED”
appears in the monitor. Turning the camera on and off with an exhausted
battery in place may shorten the life of the battery.
• If the camera is on a tripod, remove it from the
tripod before proceeding to the next step.
• Pressing the battery-chamber cover latch ⁄, slide
the battery-chamber cover out ¤ and flip it open
‹.
• Close the battery chamber cover (1) and slide it to
the closed position (2). To prevent the battery being
dislodged during operation, be sure that the battery
chamber cover is properly latched.
• Insert a rechargeable Nikon EN-EL1 lithium-ion battery or 2CR5 (DL245)
lithium battery as shown.
EN-EL1 2CR5 (DL245)
COOLPIX885 (E) 01.10.22 5:59 PM Page 44