Nikon 885 - Manual (Page 77)

153 152
Refer
ence—Adv
anced Photog
raph
y
Auto Bracketing
In situations where it might be difficult to obtain a
proper exposure, auto bracketing lets you shoot
the same subject at three or five different
exposures. In WB Bracketing, the white balance is
bracketed in three shots.
SELECT SET
AUTO BRACKETING
Off
On
WB Bracketing
OFF
Option Description
Off Bracketing is off and normal exposure control is used.
On
Auto bracketing is performed with the selected number of
bracketing shots and with a compensated EV value offset from
the automatically metered exposure.
WB Bracketing
The white balance is bracketed when you press the shutter
release button fully giving three shots made up of one with the
selected white balance, a reddish image and a bluish image.
• The time required to save bracketed images to the CF
memory card is three times that required for a normally
recorded image.
— On —
Each time you press the shutter release button, either
three or five shots are taken ranging from over exposed EV
values to under exposed EV values. When photographing
a high-contrast image, the image with the desired
exposure can be selected from the set of bracketed shots.
Number of shots, compensated EV value Bracketing order
3, X 0.3 +0.3, 0, –0.3
3, X 0.7 +0.7, 0, –0.7
3, X 1.0 +1.0, 0, –1.0
5, X 0.3 +0.7, +0.3, 0, –0.3, –0.7
5, X 0.7 +1.3, +0.7, 0, –0.7, –1.3
5, X 1.0 +2.0, +1.0, 0, –1.0, –2.0
To perform auto bracketing or white balance bracketing in Continuous or VGA
Sequence mode (p. 139), hold down the shutter release button fully. A selected
number of consecutive shots are taken, after which the sequence stops
automatically.
Notes: Auto Bracketing and White Balance Bracketing
• Bracketing cannot be set in Multi-shot 16, Ultra HS (p. 139), Best Shot
Selector (p. 141), AE Lock (p. 148) or Noise Reduction mode (p. 154).
• White balance bracketing cannot be set in Continuous mode other than Single
(p. 139), Best Shot Selector, AE Lock or Noise Reduction mode.
Note: When setting auto backeting or white balance bracketing
Before setting auto bracketing or white balance bracketing, make sure to turn
Noise Reduction (p. 154) off.
The exposure compensation indication ! along with the
compensated EV value for the next shot are displayed in
the monitor when the bracketing is set.
SELECT SET
AUTO BRACKETING
Off
On
WB Bracketing
OFF
— WB Bracketing —
White balance is bracketed when you press the shutter
release button fully, giving three shots made up of one
shot with the selected white balance, one reddish image
and one bluish image.
SELECT SET
AUTO BRACKETING
Off
On
WB Bracketing
OFF
When you select white balance bracketing, the bn
(White Balance Bracketing indication) appears in the
monitor.
COOLPIX885 (E) 01.10.22 6:02 PM Page 152