Nilfisk-Advance America GD 930 - Manual (Page 7)

7
1. To open
a) Loosen the two snap lockings by pulling them outwards
b) Lift the cover from the container.
2. Dust bag
Fit the opening on the dust bag over the air inlet. Press the
membrane over the flanged edge on the inlet. Secure with
the lock washer. Use only original dust bags.
3. Hose connection
Push the hose coupling all the way in and turn clockwise.
4. Wand assembly
Standard: Fit the sections together and twist to lock in
place.
Telescopic: Push down the catch and then adjust the length.
Max.950mm,min.630mm.
5. Tools
The accessories shown in the pictures may vary from model
to model.
a-b)Combination nozzle
Adjust the nozzle according to the requirements of the floor
you are cleaning. Work with the brush on hard floors and
without it on soft floors.
c) Universal nozzle
for both hard floors and carpets.
d)Crevice nozzle
Use to clean furniture, radiators and others hard-to-reach
places.
e)Small combi-nozzle:
The small combi-nozzle combines a dusting brush for furni-
ture, picture frames, mouldings etc. with a fold-out nozzle for
cleaning curtains, furniture and other soft surfaces. The clip
on the hose handle holds the nozzle when it is not in use.
6. Suction control
The suction control in the hose handle lets you regulate the
air-flow to prevent the nozzles from fastening to the surfaces
you are vacuum cleaning.
7. Start/Stop
a) Foot-operated on/off switch.
b)On the S2 version a separate switch is provided to
change the motor speed .
c)Plug-in point for powered carpet nozzle.
Power is supplied to the socket when the machine is
switched on.
8. Warning!
Never attempt to vacuum liquid, glass fragments or
ashes!
Wet surfaces can expose the operator to possible
electrical shock.
9. Filter
The filters are located inside the lid. To reach them lift out
the filter holder (a). The standard filter(b) and fine filter (c)
should be inspected at regular intervals,e.g. when you
change dust bags, and replace if necessary.Instead of
these two filters you can fit a micro filter of HEPA-quality (e),
wich traps 99,99% of all particles larger than 0,3 microns.
The machine is also fitted with a backup filter (d) located
above the motor. This filter should also be inspected and
replaced if necessary.
IMPORTANT!
The GD 930/S2 is equipped with a specially
designed cable, which if damaged, must be replaced by
a cable of the same type. These cables are avaible at
authorized service shops and must be installed by trained
personnel.
The GD 930/S2 is equipped with a thermal cut-out to protect
the motor and other vital machine parts from overheating.
Should the machine cut out, you will have to wait at least
5-10 minutes for it to automatically reset. While you are
waiting, switch the machine off and unplug it, then check
the hose, dust bag and filters to be sure that nothing is
blocking the flow of air through the machine.
NB!
Remove the plug from the socket before performing service
or maintenance.
The symbol on the product or on its packing indicates that this
product may not be treated as household waste. Instead it shall be
handed over to the applicable collection point for the recycling of elec-
trical and electronic equipment. By ensuring this product is disposed
of correctly, you will help prevent potential negative consequences for
the environment and human health, which could otherwise be caused
by inappropriate waste handling of this product.
For more detailed information about recycling of this product, please
contact your local city office, your household waste disposal service or
the shop where you purchased the product.
822 9393 000 Instruction for use GD 930 EU.indd 7 2008-06-26 13:06:12