Nilfisk-Advance America GD 930 User Manual
Page 8
8
PLEASE READ THESE ESSENTIAL INSTRUCTIONS
(Only applicable to UK)
GD 930/S2 are designed, developed and rigo-
rously tested to function efficiently and safely
when properly maintained and used in accor-
dance with the following instructions. These
instructions have been prepared with safety and
efficiency paramount.
The MACHINE OPERATOR must be trained
by a suitably qualified instructor, and be made
aware of the relevant regulations and legislation
currently in force at the time of use.
CAUTION - This machine MUST NOT be used in
explosive or inflammable atmospheres or where
such atmospheres are likely to be produced by
the presence of volatile liquid or inflammable
gas or vapour.
CAUTION - In no circumstances should the power
supply cord be wrapped around fingers or any
part of the operators person.
CAUTION - The electrical supply plug must not
be subjected to undue stress by pulling on the
power supply cord.
Your MACHINE must only be connected to an elec-
trical supply of the same voltage and frequency as
indicated on the rating plate. Ensure that the plug
fitted to the end of the power supply cord is suitable
for your supply socket, if not refer to the information
contained in 'Electrical Connections', or consult a
qualified electrician. The electrical installation from
which the supply is drawn must be maintained to
current Institute of Electrical Engineers wiring re-
gulations.
REGULAR SERVICING and INSPECTION of your
machine must be carried out by suitably qualified
personnel in accordance with relevant legislation
and regulations. In particular, electrical tests for
earth continuity, insulation resistance, and condition
of the flexible cord should be checked frequently.
In the event of any defect the machine MUST be
withdrawn from service, completely checked and
repaired.
Trained Service Engineers will be pleased to carry
out on site servicing on a regular or as requested
basis, to ensure the continuing safety and efficiency
of your machine.
822 9393 000 Instruction for use GD 930 EU.indd 8
2008-06-26 13:06:13