NETGEAR ReadyNAS 3200 - Manual (Page 24)

ReadyNAS 3200 Hardware Manual
2-6 Diagnostics and Maintenance
v1.1, July 2009
1. While using a paper clip or push pin to gently press in the reset switch, power on the unit. Wait
for the two red boot menu status lights on the front to display, then release the reset switch.
2. Push the Reset button on the front panel three times to select the OS Reinstall option.
The system will do the following:
a.
Display the OS Reinstall blink pattern.
b. Hold the display of the final LEDs (off on), and wait for you to confirm the selection.
3. Press the and hold the reset button for 3 seconds to confirm the menu selection and proceed
with that option.
The system will do the following:
a.
Blink both LEDs twice to confirm the selection.
b. Proceed with reinstalling the firmware.
c. Reboot when the firmware reinstall completes.
The data will be in tact. The user name, password, and system configuration settings will be
the factory default values.
Control Panel Boot Menu Options
Warning: If you mistakenly select the Factory default option, all data on the unit
will be deleted. If you are unsure, let the system boot normally, before
attempting this procedure again.
Red
Power
LED Red
Fan
LED
Boot Menu Sequence Red Power LED and Red Fan LED Blink Patterns
LED Legend: 
Off Off

On On
  
Off On
Boot Menu Enabled 
1. Normal Boot   
2. Factory Default
3. OS Reinstall     
4. Tech Support
5. Skip Volume Check
6. Memory Test
7. Factory Test