NetComm NP5400 - Manual (Page 12)

www.netcomm.com.au Rev. 1 - YML668
Page 12 NP5400 11g Wireless Access Point User Guide
TCP/IP Setup for Windows 2000
1. At the Windows 2000 desktop, right click My Network Places and select Properties. Then,
right click Local Area Connection. Choose Properties.
2. If the TCP/IP Protocol is listed for your network adapter, go to step five. Otherwise, click
the Install button.
3. When the Component Type window appears, select Protocol, and click the Add button.
4. Select Internet Protocol (TCP/IP) from the list and click the OK button.
5. When the Local Area Connection Properties window reappears, select TCP/IP, and click the
Properties button.
6. Select Use the following IP Address.
7. Enter an IP Address for the computer, along with a Subnet Mask and Default Gateway.
Then, click the OK button. If you do not have these values, consult your network
administrator.
8. When the Local Area Connection Properties window reappears, click the OK button. TCP/
IP has now been successfully installed.
TCP/IP Setup for Windows XP
1. Click the Start button and open the Control Panel.
2. Double click the Network and Internet Connections icon.
3. Double click the Network Connections icon.
4. Right click the Local Area Connection icon and select Properties.
5. If the TCP/IP Protocol is listed for your network adapter, go to step five. Otherwise, click
the Install button.
6. When the Component Type window appears, select Protocol, and click the Add button.
7. Select Internet Protocol (TCP/IP) from the list and click the OK button.
8. When the Local Area Connection Properties window reappears, select TCP/IP, and click the
Properties button.
9. Select Use the following IP Address.
10. Enter an IP Address for the computer, along with a Subnet Mask and Default Gateway.
Then, click the OK button. If you do not have these values, consult your network
administrator.
11. When the Local Area Connection Properties window reappears, click the OK button. TCP/
IP has now been successfully installed.