NetComm NP5400 - Manual (Page 18)

www.netcomm.com.au Rev. 1 - YML668
Page 18 NP5400 11g Wireless Access Point User Guide
The Access Tab
The Access Tab allows you to set the filter to specific wireless client device(s).
Enable access control: If it is checked, the AP will start to filter any wireless client
device with MAC address listed below.
MAC address #: Please enter the MAC address of the wireless devices which
need filtered in wireless LAN network. The device with same
MAC address listed will not be able to associate with this
AP.
Note: Click button "Save" to store the settings. The settings will work after AP
automatically reboots.
The Advanced Tab
The Advanced Tab allows you to configure advanced 802.11 settings
Preamble type: Enables to select different preamble types: Long, Short or
Auto. While Short type is selected, the performance may be
improved with the possibility of incompatibility
Max associated stations: Enables to set the limit of the maximum number of associated
clients. In order to get a better performance, it is suggested to
set "8" as the maximum number of associated clients to get a
balanced performance
Fragmentation threshold: The threshold which a data packet will be fragmented.RTS
threshold: The threshold which a RTS packet will be sent
before a data packet is sent.
Beacon period: The period in millisecond a beacon will be sent.DTIM
interval: Number of beacon intervals between successive
DTIM (Delivery Traffic Identification Maps).
Note: Click button "Save" to store the settings. The settings will work after AP
automatically reboots.