Nvidia MS-7374 - Manual (Page 111)

C-9
JMicron RAID
Solving a Mirror Conflict
A Mirror conflict occurs when both disks in a RAID 1 (Mirror) configuration are
unplugged from the system in turn, then plugged in again. Since both disks contain
exactly the same data, the system will be unable to determine which of the two is the
source drive. This option allows you to set the source drive and rebuild the Mirror
drive according to the contents of the source drive.
To solving a Mirror conflict:
Select Solving a Mirror Conflict and press <Enter>. In the Hard Disk Driver List
menu use <Space> key to select the disks you want to set as source drive. Using the
<TAB>, move to the RAID Disk Drive List menu and highlight the RAID set that you
want to rebuild. Press <Del> to begin rebuilding the Mirror configuration.
A status bar at the bottom of the screen shows the progress of the rebuilding.