Nvidia MS-7374 - Manual (Page 26)

2-12
M S-7374 M ainboard
Connectors
IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive.
IDE2 (Secondary IDE Connector)
IDE2 can also connect a Master and a Slave drive.
IDE Connector: IDE1 / IDE2
This connector supports IDE hard disk drives, optical disk drives and other IDE devices.
Important
If you install two IDE devices on the same cable, you must configure the
drives separately to master / slave mode by setting jumpers. Refer to IDE
dev ic e
’s documentation supplied by the vendors for jumper setting
instructions.
IDE1
IDE2