Netopia 4622 T1 User Manual
Page 10
2-4 Getting Started Guide
Netopia 4622 back panel
.
1.
Connect the mini-DIN8 connector from the power adapter to the power por t, and plug the other end into an
electrical outlet.
2.
Connect one end of the Categor y 5 cable to the T1 por t, and the other end to your T1 wall outlet.
3.
Connect the Ethernet cable to an Ethernet por t on the router and the other end to your computer.
You should now have: the power adapter plugged in; the Ethernet cable connected between the router and
your computer; and the T1 cable connected between the router and the T1 wall outlet.
Port
Description
T1 WAN por t
An RJ-48 jack labeled WAN for your T1 connection.
Ethernet por ts
Eight RJ-45 10/100Base-T Ethernet jacks. You will use one of these to configure the
Netopia 4622. For a new installation, use an Ethernet connection. Alternatively, you can
use the console connection to run console-based management using a direct serial
connection. You can either connect your computer directly to an Ethernet por t using a
standard Ethernet cable, or connect both your computer and the Netopia 4622 to an
existing LAN environment.
Console por t
A DB-9 console por t for a direct serial connection to the console screens. You can use
this if you are an experienced user. See
“Connecting a Console Cable to Your Router” on
.
Power por t
A mini-DIN8 power adapter cable connection.
WAN
Console
Power
8 port
T1 port
Console port
Power port
Ethernet
8
1
Ethernet switch