Netopia 4622 T1 - Manual (Page 25)

Console-Based Management 5-3
Configuring Telnet software
If you are configuring your router using a Telnet session, your computer must be running a Telnet software
program.
■ If you connect a PC with Microsoft Windows, you can use a Windows Telnet application or simply run Telnet
from the Star t menu.
■ If you connect a Macintosh computer, you can use the NCSA Telnet program supplied on the Netopia 4622
CD. You install NCSA Telnet by simply dragging the application from the CD to your hard disk.
Connecting a Console Cable to Your Router
You can per form all of the system configuration activities for your Netopia 4622 through a local serial console
connection using terminal emulation software, such as HyperTerminal provided with Windows 95, 98, 2000, or
NT on the PC, or ZTerm, included on the Netopia CD, for Macintosh computers.
The Netopia 4622 back panel has a connector labeled “Console” for attaching the Router to either a PC or
Macintosh computer via the serial por t on the computer. (On a Macintosh computer, the serial por t is called the
Modem por t or Printer por t. Newer Macintosh models have USB por ts, so you may need a third-par ty adapter.)
This connection lets you use the computer to configure and monitor the Netopia 4622 via the console screens.
Netopia 4622 back panel
To connect the Netopia 4622 to your computer for serial console communication, use a console cable
appropriate to your platform:
■ A DB-9 connector end attaches to a PC.
■ A DB-9 end of the Console cable attaches to the Netopia 4622’s Console por t.
■ If you connect a PC with Microsoft Windows 95, 98, 2000, or NT, you can use the HyperTerminal
application bundled with the operating system.
■ If you connect a Macintosh computer, you can use the ZTerm terminal emulation program on the supplied
Netopia 4622 CD.
WAN Console Power
Console connection port
Ethernet
8
1
DB-9 (male)