Nikon LS4000 - Manual (Page 13)

En
3
Get to Know Your Scanner
Your Scanner
³
¿
³ Status LED
This LED blinks slowly (roughly twice every
three seconds) when the scanner is in op-
eration. Do not turn the scanner off, remove
or insert adapters, or eject or insert film until
the LED has stopped blinking and is glowing
steadily. If the LED flashes rapidly (about five
times a second), a communications error has
occurred or there is a problem with the scan-
ner. Turn the scanner off, wait for at least
five seconds, and then turn it back on.
¾ USB interface connector (COOLSCAN IV ED)
Connect the USB interface cable here.
º Feet
Always place the scanner on one of its two
sets of feet.
¶ IEEE 1394/Firewire interface connector
(4000 ED)
Connect the IEEE 1394/Firewire interface
cable here.
² AC connector
Connect the female end of the power
cable here.
´ Film gate for optional SA-30 roll-film
adapter (4000 ED)
Open this gate only when you are using the
SA-30 roll-film adapter (available separately).
¿ Power switch
Press this switch to turn the scanner on
and off.
» Sliding cover
Slide the cover down before inserting a film
adapter. To protect your scanner from dust
and other foreign objects, be sure
ALWAYS
to
close the cover when no adapter is in place.
· Adapter slot
This is where you put adapters for different
types of film. Don’t put anything in this slot
except an approved Nikon film adapter.
COOLSCAN IV ED 4000 ED
Front
View
Rear
View
4000 ED/COOLSCAN IV ED
»
·
¶
´
²
¾
º