NCR Customer Display NCR 5972 - Manual (Page 32)

4-2 Chapter 4: Programming Set Up
Retail Display Commands
The following table describes the Retail Display commands supported:
Command Function
1B 01 Reset Display
1B 02 Erase Display
1B 04 Set Diagnostic State On
1B 05 Set Display State On
1B 06 Set Low Power State On (Default)
1B 07 Enable Cursor
1B 08 Disable Cursor (Default)
1B 09 Set Screen Save Blank
1B 0A Set Screen Save Walk (Default)
1B 0B Turn On Screen Save
1B 0C Disable Screen Save Feature
1B 0D Enable Character Blink
1B 0E Disable Character Blink (Default)
1B 0F Move Cursor Left
1B 10 Move Cursor Right
1B 11 Move Cursor Up
1B 12 Move Cursor Down
1B 13 Set Cursor Position
1B 17 Brightness Adjustment (Default ‐ 5)
1
1B 18 Read Display ID
1B 19 Read Display Part Number
1 This command is not supported by the LCD. The only action taken is to
take the display out of Screen Save.