NCR Customer Display NCR 5972 - Manual (Page 40)

4-10 Chapter 4: Programming Set Up
Disable Character Blink
Format: 1B 0E
Description: This command counteracts the Enable Character
Blink. The firmware implements all new character codes with an on
and holding character presentation. On power up, the character
blink modifier is defaulted to disabled.
Move Cursor Left
Format: 1B 0F
Description: Moves the cursor one position to the left. When the
cursor is at the left end of the upper line, it moves to the right end
of the lower line. When the cursor is at the left end of the lower
line, it moves to the right end of the upper line. The cursor location
always indicates the position of the next character to be displayed,
whether the cursor is enabled and blinking or not. After each
character is displayed, the firmware performs a logical Move
Cursor Right command.
Move Cursor Right
Format: 1B 10
Description: Moves the cursor one position to the right. When the
cursor is at the right end of the upper line, it moves to the left end
of the lower line. When the cursor is at the right end of the lower
line, it moves to the left end of the upper line. The cursor location
always indicates the position of the next character to be displayed,
whether the cursor is enabled and blinking or not. After each
character is displayed, the firmware performs a logical Move
Cursor Right command. When the cursor is at the right end of the
lower line, it moves to the left end of the upper line and operates in
an Overwrite Mode. The next character sent to the display
overwrites the character in the left end of the upper line.