NETGEAR DG824M - Manual (Page 29)

Reference Manual for the Model DG824M Wireless ADSL Modem Gateway
Connecting the Gateway to the Internet 2-7
c. Connect the Ethernet cable (B) from your DG824M’s LAN port to a computer.
Figure 2-2: Connect the gateway to a computer
Note: The DG824M gateway incorporates Auto Uplink TM technology. Each Ethernet LAN
port will automatically sense whether the cable plugged into the port should have a
'normal' connection (e.g. connecting to a PC) or an 'uplink' connection (e.g. connecting to
a switch or hub). That port will then configure itself to the correct configuration. This
feature also eliminates the need to worry about crossover cables, as Auto Uplink will
accommodate either type of cable to make the right connection.
d. Connect the power adapter to the gateway and plug it in to a power outlet. Verify the
following:
The power light is lit after turning on the gateway.
The ADSL link light is solid green, indicating a link has been established to the
cable network.
e. Now, turn on your computer. If software usually logs you in to your Internet connection,
do not run that software or cancel it if it starts automatically.
The local lights are lit for any connected computers.
Wireless ADSL Modem Gateway DG824M
Phone DSL
Line
B