Radio Shack CT-502 - Manual (Page 16)

16
System Busy Message
In addition to the normal busy signal you hear when a num-
ber you call is busy, your phone sounds tones and displays a
message to indicate other situations when it cannot complete
a call.
When either of these conditions occur, you can press
again to redial the number immediately (see “Using Automat-
ic Redial” on Page 20), or press
then dial the number
again.
ANSWERING A CALL
When the phone receives an incoming call, it rings or vibrates
(depending on the alert setting — see “Changing the Alert
Type” on Page 29) and
Call flashes on the display. To an-
swer the call, press . To end the call, press .
Notes:
• Your phone can receive calls even if the antenna is not
extended. For optimum performance or if the signal
strength becomes weak, however, extend the antenna.
Tone Display Shows Description
Fast Busy SND to
Redial
The cellular system is
busy.
High/low SND to
Redial
The cellular system
could not complete the
call.
SND
END
SND END
17-1111.fm Page 16 Wednesday, July 21, 1999 2:23 PM