Ricoh DDP 70e - Manual (Page 89)

Troubleshooting 5-5
OCP Display Messages
The OCP displays the printer status with 1- to 2-line messages. There are three types of
messages: status, warning, and error messages. The following table lists the messages
in alphabetical order. Each message is explained and a corrective action is given when
applicable.
For information on messages not explained here, please refer to your option-specific
user’s guide.
Message Description Corrective Action
Booklet Stacker Full
Remove Booklets
Self-explanatory. Remove booklets.
Booklet Stacker Full
Remove Paper
E027
Self-explanatory. Remove booklets.
Call for Service
Exxx or other text
Any “Call for Service” message requires
a service call for problem resolution.
Line 2 is the error code.
Contact your authorized Service
Technician and provide the error code
displayed on the OCP.
Clearing Error Status message.
Wait for the printer to return to a Ready
state.
Container x Top Cover Open
Close Cover The top cover of the container is open.
x is the container number.
Close the cover.
Container x V Path Cover Open
Close Cover
The v path cover of the container is
open. x is the container number.
Close the cover.
Creating Software Log
Status message. The printer is
creating the requested software log. Wait for the printer to return to a Ready
state.
Deleting Jobs
Status message. The selected jobs are
being deleted from the print queue. Wait for the printer to return to a Ready
state.
Developer Bottle Not Set
Set Developer Bottle E01E The developer bottle is not seated
properly.
Reseat the bottle.
Developer Charge
E0A1 Replacement of the developer is
running. Wait for the printer to return to a Ready
state.
Developer Discharge
E0A2 Replacement of the developer is
running. Wait for the printer to return to a Ready
state.
Developer Error
Retry Exhausting
E048
An error occurred when operating the
developer. Retry. If the error occurs again, contact
an authorized Service Technician.
Developer Error
Retry Operation
E047
An error occurred when replacing the
developer mix. Retry. If the error occurs again, contact
an authorized Service Technician.
Developer Mix End of Life
Replace Developer
E012
The developer mixture needs to be
exchanged. Replace developer. Printing will resume
when the developer is replaced.
Drum Unit End of Life
Replace Drum Unit
E016
The photoconductive drum needs to
be replaced. Contact your authorized Service
Technician.
Drum Wrap Sensor Error
Clean Wrap Sensor
E018
The drum wrap sensor level is
abnormal. Contact your authorized Service
Technician.
Drum Wrap
Remove Paper
E118
Simplex paper is wrapped around the
drum.
Remove the jammed paper.
Drum Wrap
Remove Paper
E119
Duplex paper is wrapped around the
drum.
Remove the jammed paper.
Duplex-Always Duplex-Always mode is enabled.
Contact your System Administrator for
additional information.