Runco VISTAGE V-50HD - Manual (Page 25)

Controls and Functions
Vistage™ Series Flat-Panel Display Installation/Operation Manual 11
PRE
L
IMINAR
Y
10. HD 1 (4) / HD 2 (5)
Press to select a HD (RGBHV or YPbPr component) input or to enter the numeric
character “4” or “5.”
11. COMP (Component) (6)
Press to select the Component video input as the source or to enter the numeric
character “6.”
12. HDMI 1 (7) / HDMI 2 (8) / HDMI 3 / HDMI 4 (0)
Press to select an HDMI input as the source or to enter the numeric character “7,” “8”
or “0.”
13. SCART (9)
Press to select the SCART video input as the source or to enter the numeric character
“9.”
14. Aspect Ratio Selection Buttons
Use these buttons to select an aspect ratio directly, as follows:
NATIVE
Displays the source signal in its native resolution, centered in the display area.
16:9
For viewing 16:9 DVDs or HDTV programs in their native aspect ratio.
4:3
Scales the input signal to fit 4:3 display mode in the center of the screen.
LETBOX (Letterbox)
For viewing non-anamorphic (“full-screen”) DVDs on a 16:9 screen.
V-WIDE (VirtualWide)
Enlarges a 4:3 image horizontally in a non-linear fashion to fit 16:9 full screen display.
CINEMA
For viewing 2.35:1 source material.
V-CINE
Selects the Virtual Cinema aspect ratio.