Runco VISTAGE V-50HD - Manual (Page 65)

Operation
Vistage™ Series Flat-Panel Display Installation/Operation Manual 51
PRE
L
IMINAR
Y
• Periodic Service Notification: You can have the DHD Controller send periodic
reminders via e-mail to perform regular maintenance tasks. To do this:
1. Select Periodic Service Notification from the E-Mail Notification menu.
2. Highlight Enable and press ENTER.
3. Highlight On and press ENTER.
4. Press MENU.
5. Highlight Timer and press ENTER.
6. Press or to set the notification interval in months. The range is from 1 to
255 inclusive; the default is 12 months.
7. Press MENU.
• Customer Information: Select Customer Information from the E-Mail Notification
menu to supply this information to the DHD Controller, which includes it in all e-mail
notification messages. Six lines (up to 30 characters per line) of text are provided;
use them however you wish.
1. Press or repeatedly to select a line of text to edit.
2. Press ENTER.
3. Press or repeatedly to set the highlighted character.
4. Press (or ) to select the next (or previous) character. Use the and
buttons to change it.
5. Press ENTER when you have finished editing that line of text.
6. Repeat Steps 1 through 5 for each line of text you want to edit.
7. Press MENU when you have finished entering customer information.
• E-Mail Calibration Data: To have the DHD Controller collect all calibration data,
attach it to a message and send it to the destination e-mail address, select E-Mail
Calibration Data from the E-Mail Notification menu. To confirm this action, select Yes
and press ENTER.
To cancel and return to the previous menu, select No.
• Remote Network Control: Select Remote Network Control from the Network menu
to enable or disable control of the DHD Controller via an IP connection (typically using a
web browser). Set it to On to allow all incoming remote network connectivity. Set it to
Off to disable any incoming network communication that was not initiated by the DHD
Controller.
This setting has no effect on the E-Mail Notification or Auto
Firmware Upgrade functions.
Note