Osd position, Service, Test video – Runco VISTAGE V-50HD User Manual
Page 61: Iminar, Ct service fro, Service m, E service me, Pre l iminar y
Vistage™ Series Flat-Panel Display Installation/Operation Manual
47
PRE
L
IMINAR
Y
• Splash Timer: When you turn on the V-50HD/V-63HD, it projects a welcome screen
with the Runco and ISF logos, along with the personalized information you enter as
described above. Select Splash Timer from the Splash Configure menu to set the
amount of time for which this screen appears. The range is from 5 to 60 seconds, in
one-second increments. Press
or
to set the timer, then press MENU.
• Splash Enable: When you have finished customizing the splash screen, select Splash
Enable from the Splash Configure menu. Then, select On and press ENTER.
OSD Position: To adjust the position of the OSD, select OSD Position from the
Calibration menu and press ENTER.
Press
or
to select “Hor.” or “Ver.” Then, press
or
to change the position.
Use the Service menu to access advanced display configuration settings. This menu
should be used by ISF-certified technicians only.
Test Video: Select Test Video from the Service Menu to access the internal test patterns
on the DHD Controller. Table 4-3 lists the available test patterns and describes their
suggested usage.
Display Device
You must enter a passcode to access the Service menu.
Table 4-3. Test Patterns and Their Suggested Usage
Pattern
Suggested Usage
Color Bars 1
Use this pattern when making
color saturation and tint
adjustments.
Color Bars 2
Use this pattern when making
color saturation and tint
adjustments.
Focus
Typically not used with flat-panel
displays.
Note