Runco VISTAGE V-50HD - Manual (Page 62)

Operation
48 Vistage™ Series Flat-Panel Display Installation/Operation Manual
PRE
L
IMINAR
Y
Press MENU to exit test pattern mode.
Input Names: You can give each input a descriptive name. For example, you may want
to change the default input name to the type of source component connected to it:
“VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press or to select
an input and press ENTER. Use the or buttons to change a character; press
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press repeatedly to highlight that input name in the
“Restore” column. Then, press ENTER.
Display Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation or access other, display-device specific functions.
• Installation – Orientation: Select Picture Orientation from the Display Device -
Configure menu, then select Orientation to change the picture orientation to suit the
method of installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, use the
Auto setting to have the display automatically determine the orientation (floor or ceiling)
using an internal sensor.
• Diagnostics: Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
Network: The options in the Network menu allow you to configure the network
communication features.
• IP Configuration: Select IP Configuration from the Network menu to either set the IP
address, subnet mask and default gateway of the DHD Controller manually or obtain
these settings automatically, from a DHCP (Dynamic Host Configuration Protocol)
server. (Most broadband routers and gateways support DHCP.) You can also test the
network connection from this menu.
Grey Bars
Use this pattern when making
brightness, contrast or white
balance (gain/offset) adjustments.
Table 4-3. Test Patterns and Their Suggested Usage
Pattern Suggested Usage
Input Names
Restore
C o mp o s i t e 1 Composite 1
C o mp o s i t e 2 Composite 2
C o mp o s i t e 3 Composite 3
C o mp o n e n t Component
H D 1 HD 1
H D 2 HD 2
S C A R T SCART
H D M I 1 HDMI 1
H D M I 2 HDMI 2
H D M I 3 HDMI 3
H D M I 4 HDMI 4