Radio Shack TAD-1006 - Manual (Page 11)

11
Mounting Directly on the Wall
To install the TAD-1006 directly on the
wall, you need a drill and two screws
(not supplied) with heads that fit into
the keyhole slots on the mounting
bracket.
1. At the desired mounting location,
drill two holes 3 15 /
16
inches apart,
one above the other.
2. Thread a screw into each hole
until the screw’s head extends
about
1 /
4
inch from the wall.
3. Plug one end of the supplied mod-
ular cord into the TO LINE jack on
the back of the TAD-1006.
4. As shown below, press the modu-
lar cord into the right groove on
the mounting bracket and press
the AC adapter’s cord into the left
groove.
5. Plug the other end of the modular
cord into a modular phone jack.
6. Line up the keyhole slots on the
bracket with the screws in the
wall, then slide the TAD-1006
down onto the screws until it is
secure.
illustration
illustration
illustration
illustration
illustration
43-768.fm Page 11 Friday, August 13, 1999 2:49 PM