Radio Shack TAD-1006 - Manual (Page 21)

21
• If the TAD answers when the
memory is full, it plays the mem-
ory full announcement, waits 7
seconds for any remote operation
commands (see “Using Remote
Commands” on Page 27), then
hangs up. The TAD cannot record
additional messages until you
delete some of the old ones (see
“Deleting Messages” on Page 25).
USING THE
ANNOUNCEMENT-ONLY
FEATURE
Your TAD’s announcement-only fea-
ture lets you set the TAD-1006 to play
a message for the caller, then auto-
matically hang up without letting the
caller leave a message. This is useful
if you want to tell callers about an
event.
Note: When the TAD is set for an-
nouncement-only, you cannot set it to
record calls using the remote com-
mands as described in “Remote An-
swer-On” on Page 27.
Recording the
Announcement-Only
Message
1. Press ANNOUNCE ONLY so the
TAD beeps twice and the ANN
indicator turns on, then press and
hold
OGM until the TAD beeps
once and the ANSWER indicator
flashes.
2. Release OGM and record your
message. Speak toward the front
of the TAD-1006 from about 12
inches away.
3. When you finish speaking, press
ON/OFF . The TAD beeps once and
plays the announcement-only
message, then the ANSWER indi-
cator stops flashing and the TAD
beeps again. The announcement-
only feature is now on.
Turning Announcement-Only
On/Off
To turn on the announcement-only
feature at any time, press
ANNOUNCE
ONLY . The ANN indicator turns on and
the TAD beeps twice.
To turn off the announcement-only
feature, press
ANNOUNCE ONLY . The
ANN indicator turns off and the TAD
beeps twice.
illustration
43-768.fm Page 21 Friday, August 13, 1999 2:49 PM