Radio Shack TAD-1006 - Manual (Page 9)

9
Replace the battery if the L.BATT (low
battery) indicator turns on while the
AC adapter is properly connected.
Cautions:
• Before you replace the battery, be
sure the supplied adapter is
securely connected to an AC out-
let and to the jack on the back of
the TAD-1006. Otherwise, you
might lose any stored information.
• Always use a fresh battery of the
required size and type.
• Dispose of the battery promptly
and properly. Do not bury or burn
it.
MOUNTING THE
TAD-1006
Placing on a Desktop
1. Plug one end of the supplied mod-
ular cord into the TO LINE jack on
the back of the TAD-1006.
2. Plug the modular cord’s other end
into a modular phone line jack.
Connecting the Wall Bracket
If you plan to mount the TAD-1006 on
a modular jack wall plate or directly on
the wall, you must first connect the
supplied mounting bracket to the back
of the TAD-1006. To connect the
bracket, insert the tabs on the bracket
into the slots closest to the battery
compartment, then press the bracket
to the phone until it snaps into place.
To remove the bracket after attaching
it, simply press in the tab on each side
of the bracket and lift the bracket away
from the TAD-1006.
illustration
illustration
illustration
illustration
43-768.fm Page 9 Friday, August 13, 1999 2:49 PM