Radio Shack TAD-1006 - Manual (Page 12)

12
7. Press up on the handset holder to
remove it, turn it over so its tabbed
edge faces up, then press it back
down into its slot on the base.
CONNECTING THE
HANDSET
To connect the handset to the base of
the TAD-1006, plug one end of the
supplied coiled cord into the modular
jack on the handset, then plug the oth-
er end into the modular jack on the
side of the TAD-1006. Place the hand-
set on the cradle.
Note: Your local Radio Shack store
carries several different lengths of
coiled phone cords. A longer cord is
especially useful if you mount the
TAD-1006 on a wall.
SETTING THE TONE-
PULSE SWITCH
Set TONE-PULSE for the type of ser-
vice you have. If you are not sure
which type you have, do this test.
1. Lift the handset and set TONE-
PULSE to TONE .
2. When you hear the dial tone,
press any number other than 0 .
If the dial tone stops, you have
touch-tone service. Leave
TONE-
PULSE set to TONE .
If the dial tone continues, you
have pulse service. Set
TONE-
PULSE to PULSE .
illustration
illustration
illustration
43-768.fm Page 12 Friday, August 13, 1999 2:49 PM