Roland HP107 - Manual (Page 26)

26
Chapter 2. Performance
Applying Effects to the Sound
fig.panel2-5
■ Adding reverberation to the sound (Reverb)
By applying the reverb effect you can produce a pleasant reverberation, making it
sound as though you were performing in a concert hall.
1
Press the [Reverb] button.
The button’s indicator will light, and a reverb effect will be applied to the sound.
To cancel the reverb effect, press the [Reverb] button, getting its indicator to go dark.
■ Adding richness to the sound (Chorus)
By adding the chorus effect, you can give the sound greater dimension, with more
fatness and breadth.
1
Press the [Chorus] button.
The button’s indicator will light, and a chorus effect will be applied to the sound.
To cancel the chorus effect, press the [Chorus] button, getting its indicator to go dark.
■ Changing the amount of effect applied
The amount (depth) of the reverb and chorus effects can be set to any of ten levels.
Changing the depth of the reverb effect
1
Hold down the [Reverb] button and press the [-] or [+] button.
The currently specified value will be displayed.
Higher values will produce a deeper effect.
Changing the depth of the chorus effect
1
Hold down the [Chorus] button and press the [-] or [+] button.
The currently specified value will be displayed.
Higher values will produce a deeper effect.
You can save the reverb on/off
setting as well as the setting for
the amount of reverb applied
in the HP107’s memory using
the Memory Backup function
(p. 45).
You can save separate chorus
effect on/off settings to each
tone individually. The original
settings are restored when the
power is turned off.
With the factory settings, the
reverb and chorus are set to
“5.”
NOTE
You cannot save separate
reverb settings to each tone
individually.
HP107_e.book 26 ページ ２００５年７月２５日 月曜日 午後４時５０分