Roland HP107 - Manual (Page 33)

33
Chapter 2. Performance
■ Changing the metronome volume
The volume of the metronome can be adjusted, with ten volume levels available.
1
While holding down the [Metronome/Count In] button, press the [-] or
[+] button.
The currently specified volume will be displayed.
Continue to hold down the [Metronome/Count In] button, and press the [-] or [+]
button to sound the metronome, and change the volume.
fig.disp-metrovol
Splitting the Keyboard Into Two Sections for
Four-Hand Performances (Twin Piano Mode)
You can divide the keyboard into two separate sections, allowing two people to
perform in the same registers.
1
While holding down the [Split] button and press the [Piano] button.
The [Split] button’s indicator will light, and Twin Piano Mode is switched on.
The following occur when Twin Piano Mode is switched on:
• The keyboard is divided into two separate sections, and the pitch
changes.
• The right pedal now functions as the damper pedal for the right
keyboard section, and the left pedal functions as the damper pedal for
the left keyboard section.
• The center pedal now functions as the Sostenuto pedal for the right
keyboard section.
• If recording is in progress or the instrument is in recording standby,
recording is stopped or recording standby is cancelled. The [Rec] button
is disabled while Twin Piano Mode is active.
• If the Split function happens to be on, it is switched off.
• The same tone and effects are used on both the left and right sides. If the
piano is in Split Play before switching Twin Piano Mode on, then the
tone selected for the right hand in Split Play is used.
* The damper resonance function is not operational in Twin Piano Mode.
2
To exit the function, while holding down the [Split] button and press the
[Piano] button.
This is set to “4” when the
instrument is turned on.
When the metronome volume
is set to “0,” the metronome
sound does not play.
C4 C5 C6 C7 C8 C3 C2 C1
C4 C5 C6 C3 C4 C5 C3 C6
HP107_e.book 33 ページ ２００５年７月２５日 月曜日 午後４時５０分