Ricoh SP C240SF - Manual (Page 300)

• On (30 seconds)
• EnergySaverMode 2
The machine enters Energy Saver mode 2 after the period of time specified for this setting is
passed. The machine consumes less power in Energy Saver mode 2 than in Energy Saver
mode 1, but it takes longer to recover from Energy Saver mode 2 than from Energy Saver
mode 1.
Default: [On] (10.1minutes) Operation panel LCD will display 10 minutes
• On (1 to 240 minutes, in 1 minute increments)
• Off
Language
Specifies the language used on the screen and in reports.
The default value for this setting is the language you have specified during the Initial Setup, which is
required after turning on the machine for the first time.
Country
Selects the country in which the machine is used. The country code you specify determines the time
and date display format and the default values of the fax transmission-related settings.
Make sure to select the country code correctly. Selecting a wrong country code may cause failures
in fax transmissions.
The default value for this setting is the country code you have specified during the Initial Setup,
which is required after turning on the machine for the first time.
Reset Settings
Be sure not to clear the settings by mistake.
• Reset All Settings
Resets the machine's settings to their defaults except the following: language for the screen,
country setting, network settings, and fax Quick Dial/Speed Dial destinations.
Press [Yes] to execute. Press [No] to exit to the previous level of the menu tree without clearing
the settings.
• Reset Network Settings
Resets the network settings to their defaults.
Press [Yes] to execute. Press [No] to exit to the previous level of the menu tree without clearing
the settings.
• Clear Address Book
Clears the fax Quick Dial/Speed Dial destinations and Special Sender list.
Press [Yes] to execute. Press [No] to exit to the previous level of the menu tree without clearing
the destinations.
7. Configuring the Machine Using the Control Panel
298
7