Regency L900E-NG - Manual (Page 27)

Regency ® L900E Direct Vent Gas Fireplace 27
INST
ALLA
TION
INSTALLATION
BACK-UP BATTERY INSTALLATION
4) Lift the heat shield up and pull out slightly to clear the head screws
and then hang it on the top bracket (located directly above the heat
shield, close to the top of the fi rebox).
3) Loosen the screw that holds the right side heat shield in place.
Heat
Shield
8) Re-install the heat shield.
2) Remove the plastic pin protectors from the battery.
5) Pull out the battery wires from the right side of the fi rebox.
1) Unsecure the battery from the outer fi rebox base fl ange by cutting the
cable tie and remove from protective wrapping.
Battery
Wires
6) Connect the red and black wires to the battery accordingly.
7) Place the battery into position on the velcro at the base of the fi rebox
as shown.